Magswitch Universal Saw Indicator merchandise When I’m looking for the

When I’m looking for the absolute cleanest cross cuts on my table or miter saw in hard or soft wood

Follow along in these step-by-step plans and the video linked below to build your own

If you need to purchase screws I recommend just getting 2″ screws to save you from purchasing two lengths

which is just slightly higher than the classic 6:1 dovetail ration

Magswitch Universal Saw Indicator merchandise When I’m looking for theJonathans Hot Take: This device makes tuning up and aligning your table saw so much easier and more accurate which is really important for good results and safety. This 2 in 1 tool can be used for miter slot to table saw blade alignment calibration and table saw fence micro adjustment indicator. It is used to measure the alignment of the table saw blade relative to the table (and the miter slot) to allow fine adjustment of blade parallelism. When